NiftyCASE right and left side tolerances

NiftyCASE’s right and left sides of the case fit very flush. It is recommended to favor a module with a pcb 1mm or more narrower than it’s front panel for use on the left and right sides of the case. See the picures below for examples of what we’re talking about…..

 
module tolerance good.png

Ample tolerance

See the left side of this module. It shows an example of a PCB that is at least 1mm narrower than it’s front panel. It should fit well in all positions in the case, including the far left and right ends.

 
module tolerance not enough.png

Little tolerance

This is an example of a module that has a PCB that is the same width of its front panel. We’d reccomend not positioning this module tightly on the far left or right sides of the NiftyCASE. The PCB will rub up against the side of NiftyCASE making it difficult for the module to have a nice fit.

We recommend positioning modules that don’t offer at least 1mm of tolerance at least 1 HP away from the far left and right sides of NiftyCASE

 

Alex’s big messy FX case. He needs to clean up his room

Alex’s big messy FX case. He needs to clean up his room